Code-3 2100 User Manual download pdf (Page 14)

PROBLEM

LED directional or

360 module not

operating when

powered.

360 corner module

has one head out.

360 corner module

has one head out.

Dimming does not

operate.

POSSIBLE CAUSE

a. Bad power/ground

connection.

b. Defective module.

a. See next

a. In front cut-off mode.

Proper functioning.

b. Check white wire between

master/slave modules for

damage or disconnection.

c. Check power and ground

of front module.

a. See next

a. No power to master.

Master(Rear) must be

powered for slave(front)

to operate.

b. Failed master.

a. White wire on module not

connected to source of +12V.

SOLUTION

a. Fix connection.

b. Replace module.

a. No problem

b. Fix white wire/connection.

c. Fix power/ground

connection.

a. Check power/ground

connections.

b. Replace entire 360

module.

a. Connect white wire to +12V source.

Follow the guide below for information on repair and troubleshooting.

LED MODULE

TROUBLESHOOTING GUIDE

Troubleshooting

All LED X™ 2100 Lightbars are thoroughly tested prior to shipment. However, should you encounter a problem during installation or

during the life of the product, follow the guide below for information on repair and troubleshooting. Additional information may be

obtained from the factory technical help line at 314-996-2800.

Note: LED modules must be replaced as a module. There are no user serviceable parts.

QUESTIONS

Are both heads

out on a 360

module, or is

this a directional

module?

Yes

Is the rear head

flashing and the

front head out?

Yes

Is the front head

steady burning and

the rear

head out?

Yes

N/A

1 2 ... 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Code-3 2100 User Manual Page 14

Comments to this Manuals

Related products and manuals for Lighting Code-3 2100