Code-3 Solex User Manual download pdf (Page 4)

Selecting Flash Patterns

Use the following instructions for lightbars without programmable light head pairs.

Note: For lightbars equipped with programmable light head pairs refer to the following:

If the lightbar has all single color light heads, please see supplement T16406 (800Series

Software).

If the lightbar has any multi-color light heads, please see supplement T54006 (950Series

Software).

STEP 1

Select the desired 3-Level mode to program by applying +power to the appropriate wire in the 16 conductor cable.

There are seven possible 3-Level modes (see Table 1). The factory default is different for each of the 3 -Level modes. The standard progressive

switch will use the Level-1, Level-2 and Level-3 modes. The defaults for Level-1, Level-2 (L1 + L2) and Level-3 (L1 + L2 + L3) are identied in Table

1A. When using individual switches, make sure to select patterns for all switch combinations.

3-LEVEL MODES OF OPERATION

MODE NUMBER WIRES ACTIVATED

L1 GRN/BLK (LEVEL-1)

L2 WHT/BLK

L1 + L2 GRN/BLK & WHT/BLK (LEVEL-2)

L3 RED/BLK

L1 + L3 GRN/BLK & RED/BLK

L2 + L3 WHT/BLK & RED/BLK

L1 + L2 + L3 GRN/BLK, WHT/BLK, & RED/BLK (LEVEL-3)

Table 1

STEP 2

Observe the ashing pattern operation and determine which pattern is in operation. Refer to Table 1A. This table shows the available ash pat-

terns. Note: the Factory Default is different and identied in the table for each of the ash mode Levels (L1, L2, L3). Once the ash pattern has been

determined, proceed to Step 3

STEP 3

Scroll to the next ash pattern by momentarily holding the Pattern Select wire (BLK/RED) to +power for ~1 sec. The light bar will stop ashing when

the wire is connected to +power. Release the wire and the next pattern as listed in Table 1A will begin to ash. The new pattern is automatically

stored each time. Repeat this procedure for each of the seven possible 3-level modes.

NOTE: To restore the Factory Default Emergency Warning Flash Patterns (see Table 1A), hold the pattern select

wire to +power for ~four (4) seconds.

SEE FLASH PATTERN SELECTION NOTES ON FOLLOWING PAGES

Make sure +12v is only applied to the function you are trying to program - otherwise program function will not

operate.

This Product contains high intensity LED powered devices. To prevent eye damage,

DO NOT stare into light beam at close range.

WARNING!

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Code-3 Solex User Manual Page 4

Comments to this Manuals

Related products and manuals for Lighting Code-3 Solex