Code-3 Banshee User Manual Page 1

1Contents:Introduction...2Standard Features...

10Specications Input Voltage 10 to 16 VDC, negative ground (earth) Note: Operation of 12V units above 15 VDC for an extended period of time may r

11Troubleshooting(Refer to wiring diagram on page 9.)PROBLEM PROBABLE CAUSE REMEDYNO SIREN OUTPUT A. NO PRIMARY SIREN SIGNAL B. BLOWN FUSE OR NO POWER

12WARRANTY Code 3®, Inc.’s emergency devices are tested and found to be operational at the time of manufacture. Provided they are installed and oper

2!The Banshee Siren is designed to be used as a secondary acoustical warning device. It is not certied to meet SAE J1849 orCalifornia Title 13. The

3Low Frequency CongurationLow Frequency Tone - The Low Frequency feature will only operate when the primary siren system is generating a tone. When

4Dual Tone CongurationThe Dual Tone feature can be used with a Z3 Siren system or with most industry standard siren systems. If the primary siren is

5Z3 Dual Tone Operation (ALT TONE)To congure the Dual Tone for the Z3 Control Head ALT TONE button, set the DIP switches according to Table 5 (refere

6Input Polarity CongurationThe Banshee has three congurable inputs (Low Frequency, Dual Tone, Air Horn). Each input can be congured for negative o

7Unpacking & Pre-installationAfter unpacking the Banshee, carefully inspect the unit and associated parts for any damage that may have been caused

8Power Harness ConnectionsThe Banshee is designed so that the main Power Harness can be connected to the vehicle battery at all times. The siren will

9Banshee Siren Wiring DiagramBANSHEE12V SIRENGND20 AMPAIR HORNDUAL TONELOW FREQUENCYSPKR 2SPKR 1IGN12GAPOWER HARNESS T56637FUSE*100WSPEAKERAIR HORNDUA