Code-3 Undercover Siren User Manual Page 6

  • Download
  • Add to my manuals
  • Print
  • Page
    / 10
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 5
6
Place the switch in the wail or Yelp position and depress the Air Horn button. The Air Horn
should override the wail and Yelp tones.
MAINTENANCE
Your Code 3
®
3000/3050 SERIES siren has been designed to provide trouble free service. In case of
difficulty, see the troubleshooting guide below. Also check for shorted or open wires. The primary cause of
short circuits has been found to be wires passing through firewalls, roofs, etc. The following periodic
maintenance is, recommended:
A. Check all terminals and connections to insure that they are tight.
B. Remove the siren cover and blow out any accumulated dust or dirt.
C. Inspect the speaker to insure that it is not clogged with dirt, leaves, etc.
A schematic wiring diagram and technical description are available from the factory upon request.
TROUBLESHOOTING
(Refer to wiring diagram page 5)
PROBLEM
PROBABLE CAUSE
REMEDY
NO OUTPUT
A. SIREN NOT CONNECTED TO
POWER SOURCE
B. EXTERNAL 14A FUSE MISSING/
OPEN
C. VEHICLE SUPPLY FUSE OPEN
EXTERNAL 14A
FUSE BLOWS.
A. SPEAKER(S) SHORTED
A. CHECK
CONNECTIONS
B. REPLACE FUSE
C. REPLACE FUSE
A. REPLACE
SPEAKER(S)
A. VEHICLE CIRCUIT BREAKERS
NOT RATED PROPERLY, AND ARE
OVERHEATING
A. REFER TO
SPECIFICATIONS
SECTION, PAGE 9. USE
A BREAKER WITH AT
LEAST TWICE THE
AMPERAGE RATING
FOR THE WATTAGE
BEING USED. (I.E. 200
WATT = 30 A MIN.)
SIREN RUNS PROPERLY
BUT SHUTS DOWN
WHILE RUNNING, THEN
STARTS RUNNING
AGAIN AFTER A FEW
MINUTES
NO OUTPUT FROM
SPEAKER, TONES
HEARD INSIDE
AMP. MODULE.
A. SPEAKER NOT CONNECTED/
OPEN CIRCUIT IN SPEAKER WIRING
B. SPEAKER(S) OPENED
A. CHECK SPEAKER
WIRING
B. REPLACE
SPEAKER(S)
SIREN TONES
VOLUME TOO
LOW/GARBLED.
A. CHECK WIRING FOR
BAD CONNECTIONS/
CHECK VEHICLE
CHARGING SYSTEM
B. CHECK SPEAKER(S)
WIRING/REPLACE
SPEAKER(S)
C. REFER TO PAGE 4
FOR PROPER PHASING
A. LOW VOLTAGE TO SIREN
AMPLIFIER
B. DEFECTIVE SPEAKER/ HIGH
RESISTANCE IN WIRING
C. SPEAKERS PHASED IMPROPERLY
Page view 5
1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments