Code-3 H2Covert Siren User Manual

INSTALLATION & OPERATION MANUAL1H2CovertTM Remote Siren Systemwith Hand-Held ControllerMODEL 3599L5IMPORTANT:Read all instruction and warnings be

Hand Held Controller (See Picture on Next Page)The microphone for talk.1. LEV1, when depressed/released once, supplies power to the load connected to

11213 45 67 810 111413121591617

12SpecicationsSiren SectionInput Voltage 10-16VDC (negative ground)Input Current 17 Amps @ 13.6VDC (dual 100W speakers) Standby Current

HARDWARE13 T15062 Hand Held ControllerMounting BracketT15061 Hand Held Controllerwith Coil CordExtension Adapter (Included in T15065Parts Bag)T15066

TROUBLESHOOTING GUIDEPROBLEM PROBABLE CAUSE REMEDYNO SIREN OUTPUT. A. SHORTED SPEAKER OR SPEAK-ER WIRES. SIREN IN OVER CUR-RENT PROTECTION MODE.A

NOTES15

WARRANTY Code 3®, Inc.’s emergency devices are tested and found to be operational at the time of manufacture. Provided they are installed and operat

2IntroductionThe 3599L5 uses an easily concealable remote hand held controller coupled to an electronic siren, all designed to meet the needs of e

3All devices should be mounted in accordance with the manufacturer's instructions and securely fastened to vehicle elements of sufcient strength

The 3599L5 amplier is not waterproof. It must be mounted in a location that is sheltered from rain, snow, standing water, etc. It must be also insta

5. To install the positive and negative power wires, strip 1/4” of insulation from the end of the wires, insert the red wire into the left port of th

6. The unit is supplied with a ten-position, pluggable connector (color green) for the other connections. Insert the wire into the connector and tig

Any electronic device my create or be affected by electromagnetic interference. After installation of any electronic device, operate all equipment si

EU Lock FeatureBy setting either Dip switch #8 or Dip switch #9 to the “on” position, the EU Lock Feature is enabled. This feature ensures that at le

Congurable Dip switchesThere are ten dip switches on the front of the 3599L5 amplier that can be used to set various different features of the sys-t